Using the resetrsa command in the to reset the Remote Supervisor Adapter to default settings

Use the resetrsa command to reset the Remote Supervisor Adapter or Remote Supervisor Adapter II to the default settings and then restart it. This command is for BIOS-based servers only.

This command takes approximately 30 seconds to complete.

Syntax

The syntax of the resetrsa command is

asu resetrsa [-nx]

Note: If the optional -nx parameter is specified, the ASU performs the operation for node x, where x is the selected node in a multi-node system. Node x can be a number from 1 through 8. If the -nx parameter is not specified, the operation is performed on the primary node (node 1).

Output

The output of the resetrsa command is a message that indicates that the restart of the Remote Supervisor Adapter is completed.

The following example shows the resetrsa command and corresponding output.

Command line:

 asu resetrsa

Output:

Rebooting RSA/RSA2...done